What should be paid attention to in the installation and commissioning of NC bending machine die

Release time：2022-03-15

Bending machine dies are divided into upper die and lower die of bending machine, which are used for sheet metal stamping and separation. The mold for forming has a cavity, and the mold for separation has a cutting edge. What are the precautions for the installation and commissioning of NC bending machine die? The NC bending machine die is composed of many parts. Therefore, the state of the equipment should be checked during installation and carried out in strict accordance with the steps. At the same time, pay attention to safety during installation and commissioning, and the installation and commissioning process of NC bending machine die.

Adjustment of the machine: before installation, first adjust the performance of the machine. This process should be patient and serious. Check whether the machine has dust and used iron debris, and clean it to reduce the trouble in the later stage.

Adjustment of slider stroke: pay attention to check the thickness of the die and whether the proportion of the upper and lower modules is normal. Normally, the module should be controlled at the switching point of the stroke line, which must be paid attention to.

Adjustment of travel module: that is, adjust the upper limit point of the module. When the module goes up to the high place, set the switch and reserve the stay position of the slider. At the same time, when it goes down, slow down the module to better protect the machine and mold.

Gap adjustment: mainly measure the distance between the upper module and the lower module first. The specific gap setting is determined according to the folded plate.

Angle adjustment: the adjustment of this angle has a certain relationship with the product. Generally speaking, when folding the 90 ° mold, the middle angle must be greater than the angle on both sides, and its tightness can be adjusted according to the adjusting screw. During bending, the pressure can be adjusted through the pressure gauge to avoid die edge collapse.